Jump to content
SAU Community

Recommended Posts

I would see 2wd as a big downside - compensated in part if it were a manual. Some RS models have no turbo.

I thought RS means "Turbo", the 4(FOUR) means 4WD. I have an RSFOUR and a 25G which is RWD,N/A, auto.

Another thing different between the 4WD and RWD is the front suspension. There is less offset on the 25G so I needed spacers to fit the 17X8s.It came with 17X7s.

I would see 2wd as a big downside - compensated in part if it were a manual. Some RS models have no turbo.

I thought RS means "Turbo", the 4(FOUR) means 4WD. I have an RSFOUR and a 25G which is RWD,N/A, auto.

Another thing different between the 4WD and RWD is the front suspension. There is less offset on the 25G so I needed spacers to fit the 17X8s.It came with 17X7s.

  • 5 weeks later...

Has anyone got a definitive resource for S1 Dayz options? Ours has the dayz kit and badging so I presume genuine. Interior plastics grey/black, cloth, twin roofs, auto tailgate, LSD, nismo 'red' shocks/springs, nismo 2.5" cat back exhaust, wiper heaters, grille is chrome slat type. Interested to know what is likely optioned from new vs accumulated over time. It has s2 rear lights but I'm presuming they were fitted by the owner.

  • 4 weeks later...

Hi all,

This is my first post on this forum! My N15 SSS Pulsar was recently stolen, and I've almost decided to get a C34s2 RS-four S as my next car :D

I have my eyes on these two Stags atm: Modified and Unmodified

I was wondering how the prices of these two examples rate? Are they about right or a bit on the expensive side?

The VIN of the 2nd example is: 6U900WGNC34138456 - if someone could run it through FAST, i'd be much appreciative.

Cheers!

Hi all,

This is my first post on this forum! My N15 SSS Pulsar was recently stolen, and I've almost decided to get a C34s2 RS-four S as my next car :D

I have my eyes on these two Stags atm: Modified and Unmodified

I was wondering how the prices of these two examples rate? Are they about right or a bit on the expensive side?

The VIN of the 2nd example is: 6U900WGNC34138456 - if someone could run it through FAST, i'd be much appreciative.

Cheers!

IMO go for the slightly more expensive one, i saw that particular one come up a couple months after i bought mine and thought dam, though it used to be advertised at $15,000 so ask the seller bout that. u will end up wanting to do alot of those mods anyway after a couple months of owning it.

*Edit - and the dayz bodykits look alot better then the standard one plus those second front fog lights are pretty rare

Edited by Pft shh 89
  • 3 weeks later...

Hi All,

Looking for some help with finding a good manual Stag, problem is I live in WA and everything for sale is not.

http://www.carsales.com.au/all-cars/results.aspx?No=0&Qpb=1&Cr=12&Ns=pCar_PriceSort_Decimal|0||pCar_RankSort_Int32|1||pCar_Make_String|0||pCar_Model_String|0&keywords=&sid=12FFA3A669BA&SearchAction=N&silo=1011&seot=1&Nne=15&N=1216%201246%201247%201252%201282%204294960181%204294963846%201622&trecs=18

Can anyone help me with acting as a sort of buyers agent?

Need someone who is going to be picky to give me honest feedback and has potentially owned one so they know what they should feel like and also what to look for..

Are any of the ones up for sale members?

I am tempted by the dealer option in SA....

Thanks.

Shane.

Have a look in the Classifieds section here and narrow your options down by doing a search with "Stagea" as your tag. There are always a few for sale here, and a majority are cars that are well-loved and cared for.

Hi all,

This is my first post on this forum! My N15 SSS Pulsar was recently stolen, and I've almost decided to get a C34s2 RS-four S as my next car :D

I have my eyes on these two Stags atm: Modified and Unmodified

I was wondering how the prices of these two examples rate? Are they about right or a bit on the expensive side?

The VIN of the 2nd example is: 6U900WGNC34138456 - if someone could run it through FAST, i'd be much appreciative.

Cheers!

more expensive one.. i did when i bought mine and glad i did.. the one i got had about 10k worth of mods and was about 3k more than a stock one so to me it made sense to do that rather than forking out another 7k to do the mods yourself.

more expensive one.. i did when i bought mine and glad i did.. the one i got had about 10k worth of mods and was about 3k more than a stock one so to me it made sense to do that rather than forking out another 7k to do the mods yourself.

:D That's what I figured - drove it home from Melbourne yesterday and went on the Adelaide Stagea cruise today!

  • 2 weeks later...

Hi All,

Can anyone tell me how common surface rust is in sills?

I am trying to buy a manual stag from over east ( I am in perth) and two cars i have got independent inspectors to have a look have found some surface rust in sills or boot floor.

First one was worse than the second, though the second had been black duluxed underneath.

The first had pretty bad bonus rust in the chassis side wall behind the strut top near the abs module... straightened out front hit?

I am guessing these are snow region cars.

How common are steering rack leaks?

Should I:

A) Wait, consider my inspection fees as gone to experience (still cheaper than flights) and try to wait for a clean one to come up

B) Use it as a tool for haggling, and deal with it by not looking too hard underneath.

I am mainly looking at dealer cars as I figure organising transport etc might be easier.

Anyone selling an RS4S in Perth?

get a straight one

or buy mine

they will nearly all have rust under the wing mirrors, but rust elsewhere isn't too common (unless its a cold pack car)

it would probably be worth importing one yourself if you can't find what you want locally, then you can specify stuff like sunroofs, dayz options, jap wheels, mods etc and save yourself quite a bit!

but your doing the right thing with the inspections be cause buying a lemon could potentially cost your $$$$$$$$$$$$$$$$$$$

Sorry champ but your in tasmania...

Thats a boat, truck then train....

have you just been looking at dealers or private?

because there are heaps for sale privately and they are so cheap now :(

Thanks for trying to sell me you cars from states even further away...

Ended up sticking with dealers.

I hope it goes on the truck tomorrow and is in WA by Friday but I think i will be lucky....

Better not be rooted....

  • 1 month later...

After someone's thoughts on this:

http://www.carsales....id=133054BF324F

Any good or no?

That one has been for sale for ages! It was available when I got mine 3 months ago (to the day).

Over priced for what it is. For that money you could get nicer, with some mods and dayz options. Check out Robbie's car in the classifieds.

Only difference is Robbie's is auto, but it is tiptronic.

Really, Robbie wants $15500 for his, and it's a great car, great colour. Surely for the $1500 difference you could do a manual conversion if you needed a manual?

For $17k you are starting to look at clean, standard M35s, or maybe even a 260?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hey @Butters, did you end up getting this clutch in ? I have just ordered to a uniclutch track to go in my getrag 6 speed that’s in my BNR 32     
    • I know you don't want to hear this comment, but I can't not say it.  I just can't see 200kw being worth the time and effort. Its like guys with NA cars, putting in headers/exhaust/tune for a massive 20% jump in power. Great, the slow car is still slow and you're down $10,000.  My vote is leave it NA or price in a gearbox upgrade and shoot for at least 300KW, preferably 350KW+.  Now you have a NC that will try to kill you from time to time and will be exciting to drive
    • Ah yep. The main message I want to pass on is, try not to get scared of ghosts when thinking about knock/knock detection.  What I mean is, healthy engines make noise. Knock is also noise. Your knock sensor and ECU combo are trying to determine bad noise from good noise based on how loud the noise is. The factory knock sensors and ECU are not good at doing this.  Modern ECU's are pretty decent at it, however I'd still say that you would want to verify that if your ECU says it's knock, that you actually listen to it and confirm that it is correct.  Are you familiar with the plex knock monitor?  https://www.plex-tuning.com/products/plex-knock-monitor-v3/ I expect you're the type of person that would be very keen to play with something like this. It is great knock detection and you can pop some headphones on and listen to what's going on.  Knock that you've deliberately induced in low load low RPM areas is not really putting anything at risk and is a great tuning/learning/verification tool.  I just thought this was worth mentioning based on the way you were talking about setting up a base map and the Haltech base map settings. There are better ways to spend your time then chasing ghosts and worrying about detonation in scenarios that it is crazy unlikely to encounter it.  I was also wondering, what ECU are you planning to get? Will it be long til you pick it up?
    • This came quicker than I thought. It ain't even 2025 yet.
    • I somehow quoted my post instead of editing it. I regret nothing.
×
×
  • Create New...