Jump to content
SAU Community

Recommended Posts

lol.

Title says how fast - need to know the power

Thread says how much power - well thats dependant on so many things, you could have a whole 80rwkw variance easily

... and its just come from Japan.

MY bet is the motor is on its last legs, 21-secs with getting out and pushing from 3/4 track

I'll bet it takes even longer than 21 seconds.

With the Christmas school holidays, you'll have to granny it off the line and do the speed limit unless you want to get pulled over by the cops and asked to pop the bonnet on that thing.

As for power, I'd say at least 280ps at the flywheel.

Edited by scathing

at a glance id say roughly 364.35325345 rwkw

depending on colour of car.. if red... might have to add 12 more

and considering the brakes arn't slotted... youd wanna compensate. im surprised it doesn't have any air-freshener mods... tragic

but because it doesn't have PETROL listed i wouldn't say it has any power at all... to be exact

lol.

Title says how fast - need to know the power

Thread says how much power - well thats dependant on so many things, you could have a whole 80rwkw variance easily

... and its just come from Japan.

MY bet is the motor is on its last legs, 21-secs with getting out and pushing from 3/4 track

Sound like a thread to get some attention.

People still think importing a trashed GTR with all those apparent parts is gonna be the greatest thign since slicked bread :)

I think it will break something on its first dyno run and then spend the next 12 months in a workshop as the owner wont have any $$ to fix it

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • FWIW the depth of the groove in the rubber pad is not super essential, the blocks are rubber and squish a bit. If you are worried an angle grinder will make a deeper groove quick smart
    • I mean, if you were to move the jacking points away from the original location, that is, away from the wheels and closer to the centreline of the car, then it will be more likely to overbalance and tip off the supports. Same as we talked about before. I was talking about moving for-aft. If the sill is bent outward or inward, then the car would obviously look unstraight from the outside. Hopefully that hasn't happened either. Again, you can do comparative measurements from the chassis rails to see if there is much deflection.
    • Can you elaborate what you mean with your first sentence? I meant move as in the bulge kinda seemed like it got pulled "outward" meaning it got pulled down and to the side with the jacking rail itself, so the load bearing bulge now sits lower than usual and is not level with the sill on the other side of the jack point. Either that or the jacking rail just got pushed in a good bit.
    • As well as being risky WRT tipping off anyway. Yeah, I wouldn't expect it to move. Just measure from the rear one to the front one on the good side, then measure that same length on the wrecked side. You will find the notches in the pinchweld, and the jacking pad. Just spray a spot of marker paint or something there.
    • but any other area than the bulge you are talking about will just cave in then? The front driver side is pretty bent so I don't know if that will work the way it is now. I can still kinda make out where that bulge is/was but it looks like the position of it also changed due to all the mistreatment? Hard to tell
×
×
  • Create New...