Jump to content
SAU Community

Recommended Posts

Just got a 96 GTR and my mechanic has recomended first point for upgrade to wack a 3.5'' exhaust right through.

Wondering what is Legal and How do I find out what the legal limits are in QLD.

Also he rekons it will add about 40 rwkw , does anyone have any experience with this ??

regards sb..

Link to comment
https://www.sau.com.au/forums/topic/95652-r33-gtr-exhaust-upgrade/
Share on other sites

The problems you will have is with the car being to low due to the exhaust going under the diff/drive shafts ect, the police will love to defect you for this, and also the biggest problem you will have is noise. 92 DB is the legal limit, i have a 3" exhaust right through and without the silencer i'm 102db @ 5100rpm. You should gain a fair bit of power from those mods, when doing this also get a set of pod filters or get a good pannel filter, something less restrictive. You should be able to up the boost to 1 bar and should be making around the 200awkw mark. Mine has the following done and is making a tad bit more power than that.

96gtrman i made my own 3.5' system with with twin 3' down pipes into 3.5' straight throught two the rear where at the time i could not buy the muffler(s) i wanted so as a tempary measure i cut the back off the standard unit gutted it and fitted the 3.5' into rear with the twin 2.5' standard tail pipes, the result was quiet awesome since then i have made 530rwhp with the system and i great a number of comments on the note of the gtr which is not really that loud so cruising isnt a problem/or police but it still has a nasty angry note. I used all mandal bends and also made custom 3' one piece dumps(like what tomei sell)

pete

ps if you take your time fitting it you can have it hang at the same height as std the diff is not a problem

Edited by pnblight

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Nah it factory manual not sure about ratio but it looks like there’s been some work at the rear 
    • so I need a new speedo cable 
    • Throwing my spoon to the soup here a bit.  When I installed a 044 back in 2012, along with the direct power mod, the car became very difficult to start. To a point I burned one starter motor as I was late for work and tried to get the thing going. With some tuning and careful use of gas pedal when cranking it became bearable. Trying to make this short as possible, but the 044 died after 2-3 years, after which I went with an AEM 320lph pump, which also died after about 4 years to my dismay. After that I went with a Nismo pump, and while trying diagnose an emissions problem, I noticed for the first time that my fuel pressure was 5bar/72psi on idle, and that removing the vacuum line did nothing. After monitoring the situation, and removing the direct power feed and going back to FPCM in attempts to remedy it, I noticed there was fuel in the pressure regulator vac line. Kept the FPCM, installed AEM external regu and the car became sooo much better in every way, including starting. And I had driven it like it was for 11 years.. Anyway, I agree these are likely two different problems, and the FP problem you just haven't noticed before. I do not know much about haltecs, but what first came to mind was the CAS, which probably is not there any more. So how is the wiring from haltec to gauge cluster? How is the battery voltage and alternator?
    • Your car was auto before? You have different diff ratio (auto vs manual i think? or n/a and turbo?)
    • +1 for getting a screen off alibaba, CarPlay/Android Auto is vastly better than whatever navigation cars had 10 years ago. I got an Android screen for my 2015 BMW, huge difference. Fully compatible with factory stuff including iDrive controls.
×
×
  • Create New...