Jump to content
SAU Community

Apexi - Power Fc Boost Controller Kit


Recommended Posts

bass junky uses it perhaps you could ask him

boost is really a set and forget kinda thing

so im sure its just a little awkward doing the initial setting and then its fine and the even bonus is the hand controller will plot / show boost pressure.

Link to comment
Share on other sites

I haven't heard that much bad on the pfc boost controller kit.

Bass junky holds 14psi nice and solid, Steve's R33, HKS3037S & cams made 320rwkw, that held 20 something psi no problems. No tailing off is what I am getting at, cheap ebc's will tend to tail off when the turbo is pushed near its limits.

Edited by Cubes
Link to comment
Share on other sites

No problems with mine either.

My stock turbo rb25det came onto boost a lot earlier than before (bleed valve) - made it really nice and responsive around 100km/hr in 5th etc. Good that it works in with the pfc too and held boost as good as the stock turbo could manage.

Will see how it copes with a turbo upgrade over the next week.

I doubt the guys who've had problems have installed/tuned theirs properly - or they have rare defective boost controllers

Cheers

Link to comment
Share on other sites

Can some one do a test for me?

Cruise up a hill around peak torque.. Say 3000rpm or greater, while cruising up that hill bring boost up a little and try to hold a constant speed ensuring boost is being made, then flatten it quickly.. Does boost spike?

From my playing with elec auto self learning boost controllers this scenario is where they tend to have issues with a little spiking.

gtst25, so yours dropped a little boost up top?

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Just ordered those bosses, hopefully that does the trick thank you very much everyone for your replies it's really appreciated  
    • to have this type of adjustment possible with a curve as I wish, what budget (engine) should be planned?  
    • People still have Skylines? I thought they're non-existent now. 
    • Harness update time have had great fun and learnt so much already so far with this project. I started off making both the ignition and injector sub harnesses in the hope any mistakes i made here aren't as hard to undo and learn from as the main harness.  A cool comparison of the old harness using presumably TXL wire and the new which is using Tezel. Also opted to use DTM plugs to keep the whole setup as neat and tidy as possible and tucked the wiring under the coil bracket to try and keep it all from sticking out too much. Although the injector harness, I'm not overly happy with as I'm still using the rubber boots that are supplied with the type of plugs it just looks ugly and sticks out like a sore thumb with the white identifiers so a slight redesign may be done.   Then it was main harness time and most importantly trying to route it nice and away from the heat it will use the OEM heater hose routing which is no longer present to keep the harness up high and secure. it's amazing how much smaller this harness is able to be compared to the old one. plugged everything into the emtron and with the help of the tuner again attempted to start it up and instantly fired up and running smoothly on all 6 which was a big shock to myself. So still some routing and adjusting to be done for the final fit up and installing a knock sensor harness plug which is in the post all has gone surprisingly well.     The old harness for shits and giggles.
    • They do that at random every now and then, with almost no detectable cause. Mine has done it a couple of times (over 25 years!!). Never worked out why.
×
×
  • Create New...