Jump to content
SAU Community

Recommended Posts

Hi, i just bought a 89 R32-gts-t which has some major heating issues.

I've already spent a bit having a full service done and a couple of other things to try and fix this very annoying problem, but before i go and throw some more money at it i thought i should ask what you guys think it is.

It basically is always over heating even in the cold morning after 5 minuets of driving i can feel the heat coming through the floor and after a little while it starts to lose power then get it back very quickly making it bunny hop, it mainly starts to do this as the boost pressure rises above 2 pounds, but some times this problem will come and then go away but it seems to be getting worse and happening more often, also sometimes if i slam it for a bit it will go away for 30 minutes or so,When i slow down to take a corner or sit at lights it will stall sometimes and when i start it, it will rev up to 2,000 revs then bum out to 500 revs and keep doing this over and over then stall again.

I've already flushed the radiator twice and replaced the thermostat but it's still doing it.

In the next few days I'm going to get the temperature sensor replaced in a effort to try and fix the problem, the temp gauge wont go above half way even when the motor is so hot it wont start so maybe that is why it is doing it, i dunno.

If anyone knows what this is and how to fix it please let me know.

Have you checked for any leaking hoses or loose piping. Maybe cracked vaccum lines or water hoses. Is the car losing coolant?

Checked ya plugs?

Checked ya coilpacks?

Fuel Pump?

Fuel Filter?

What was changed or done at last service?

It did have a cracked hose that was leaking coolant but i got that fixed, i also replaced the temperature sensor just in case the computer was getting wrong signals, i had the computer checked for errors and it said there were non.

Yea the plugs got replaced at the service, The coil packs weren't touched in the service, But as for the fuel pump and fuel filter i didn't think to get them replaced, I'll get them done later in the week if you think it might fix it.

But as for the water pump i don't think there are any problems there because since i had the thermostat replaced i can see the coolant flowing through the radiator nicely.

Edited by Seb,

It was leaking near the firewall, but since i got it fixed i haven't noticed any change in performance or cooling, It's still running pretty hot.

The biggest problem besides all the things that have been happening, is that it doesn't always do it, So when i take it in to get it fixed there's nothing wrong with it.

Maybe the car is running lean and thats why it's over heating, Don't know how that could be because it go's through heaps of petrol, Just a thought.

I'm going back to the mechanics on Wednesday when i get payed, So what should i get done first?

Edited by Seb,

Jeez man, I got a friend with a SR20 180, same problem as you describe. The biggest problem is when we take it to our mechanic, the car doesn't act up - mech thinks we're paranoid. I went to hook up my diagnostic computer and it didn't do it then either! I have a theory, there might be some crud in your fuel tank, because It always seems to happen when he is very low on fuel. Try filling up to the brim and see if it goes away.

If we fix the problem on the 180, I will try and remember to post it here.

Overheating R32's... how I loathe this problem...

Dude get the radiator core checked - This was the main culprit behind my overheating issues - it corroded from the inside out, hard to spot..

Also check your heater core - look for wet floor its a tell tale sign...

farked thermostat won't cause overheating - they rarely fail while they are closed.

Are you losing coolant each time??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Grind them off, drill them out. Repair any rust on the other side. Start again from scratch.
    • Big R34 GTR parts cleanout. I have a lot of stuff collected over the last 14 years and my missus is giving me hard time. Make my life easy.   Nismo GT carbon fibre diffuser fins (discontinued)  NEW  $2900 Garage Defend Stingray canards carbon fibre  NEW  $1300  Top Secret G Force carbon fibre front diffuser  NEW  $2000  Haltech Elite 2500  NEW  $2500  Haltech Platinum Pro R34 GTR   USED  $1400  Apex’I power FC D'jetro + hand controller R34 GTR   USED  $1400  Nissan OEM BNR34 ECU  USED   $1000  HKS EVC 6  USED  $600  Blitz dual SBC ID boost controller.  USED  $350  TRE 255 LPH Fuel pump  NEW  $100  Fujitsubo  Super Ti exhaust  USED  $2700  Tomei Expreme Ti exhaust  USED  $2000  Trust stainless steel front pipe  USED  $1000  Apex’I super suction kit  USED $400  BC BR coilovers  USED  $600  Hardrace front upper camber kit. USED  $300  Garret 2860-5 turbos –  one good, one needs reco USED  $1000  Nissan OEM Toshiba MFD Screen replacement  NEW  $450  Nissan OEM BNR34 Series II front passenger seat  USED (mint) $5000   Nissan OEM BNR34 front bar in TV2  USED  $1000  Nissan OEM BNR34 front lower air spoiler  USED  $900  Nissan OEM BNR34 front lower air spoiler (painted)  USED  $900  Nismo front indicator (clear) USED  $80 Nissan OEM BNR34 radiator  USED $500  Nissan OEM BNR34 turbos  USED  $500  Nissan OEM BNR34 intercooler USED  $800  Nissan OEM BNR34 front swaybar   USED  $500  Nissan OEM BNR34 intake pipes   USED  $400    Also have a square set of uber rare Volk CE28n in 19*10 +22. Not really keen to sell these but make a high enough offer and maybe I will. If you don't know how much these usually sell for don't bother.   PM for pics.  Pickup Chadstone VIC or postage at buyer's expense.
    • Thanks Mate, I did know you could do that but i know there is a pump out there that you can bolt on and it all lines up. I was told about it and then forgot the model, I figure if i am pulling it apart i will just put a new one on 
    • You can also remove the veins from the HICAS portion of your existing pump. 
    • Trying to swap the rear subframe on my R34 and can't remove the L-shaped stay brackets between the front subframe mounts and the sill/chassis. I'm in the UK so rust is a problem. I've used loads of WD40 and then Tunap 103 for days beforehand. I backed off the bolts forward a bit, backward a bit repeatedly for ages to try and avoid snapping. They have all moved a few full turns. The one I've spent most time on has come loose and I can turn with fingers, and it will pull down and push up 2-3mm. But it won't come out. I can tighten it back up and loosen it off again repeatedly but it still won't come out. I assumed there's a captive nut inside but if that's broken loose then I can't understand why I can always tighten the bolt back up - I'd expect it to just spin both ways. Any ideas what's happening here? I can't visualise what's inside there to cause this.
×
×
  • Create New...