Jump to content
SAU Community

Recommended Posts

1979 Ford Falcon Ute

ZL Fairlane Front end

Nice Paintjob Green/blue changes in the sun.

5 spoke "Draglite" Dragway Rims

New Interior

Lots of chrome...

Mods:

351 Clevo with 650 holley quad barrel

chrome air filter

chrome rocker covers

Cams

Extractors

Twin Exhaust with just one single muffler on each side

New sparkleads and points

Electronic Ignition (converted)

Toploader with LSD

Disc brakes all around with machined rotors and new brakes.

Also has front lowered king springs

new shocks

rear has 2.5inch lowering blocks

Extra:

Two 6 x 9 kenwood in the back of the cab, Front 4 inch 2 way in dash and a

pioneer head unit. You do not need this stereo, the sound of the engine is

much better. This thing attracts looks so if you like to be noticed this is

the type of car for you...Its Loud and Proud

Location: Gold Coast, Queensland

Price: $6000 - PRICE DROP $5800

pm me - its a mates car

Edited by delliii
Link to comment
https://www.sau.com.au/forums/topic/98240-ford-v8-ute/
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Best practice for any track day should be Bleed brake fluid, inspect rotors and pads maybe even flip pads if they are prone to tapering.  Quality pad (project mu, endless, hawk, winmax, ap), Good high carbon content rotor (dba4000/5000, Ap, projectmu), Quality fluid, Good air supply over the rotor and caliper are all required for best performance at a track day no matter the car.  Even the bedding in of the pad and rotor is key to longevity. I've seen so many rotors destroyed on their first track day due to it. 
    • The hardcore tracks1ut guys I know would flush their brake fluid every 6 to 12 months depending on the amount of track work they did. Unlike most of us SAU guys, probably flush it once a decade 🥲
    • Now that these are NLA, I suspect the answer is going to be to 3D print the plastic bit and glue on some felt or something to replace the brush. I have one or two of them (new) in the shed to go onto the car at some point. I could put some effort into measuring them up and could attempt to draw up the printed part in FreeCAD, if there is interest.
    • Hey team, the R32 ones look different to the R33 and 200SX ones. Also they're sold out on Amayama, looks like some dealer cleaned up the stock.
×
×
  • Create New...